Application:
E7218M
DODGE CALIBER 07-08 L4-2.4L
JEEP COMPASS 07-14 L4-2.4L
JEEP PATRIOT 07-14 L4-2.4L
This video is about how to install an E7218M fuel pump in a 2007 – 2014 Jeep Patriot. Airtex is committed to providing the most up-to-date, in-depth fuel pump replacement information that professional technicians need to diagnose, repair and install today’s complex fuel delivery systems. Airtex is the only U.S. automotive aftermarket manufacturer that designs and builds electrical AND mechanical fuel delivery system components, including modular reservoir assemblies, electric fuel pumps, mechanical fuel pumps and in-tank sender and hanger assemblies, for a full range of car, truck, fleet and specialty vehicles.
anyway if you know if the 2017 renegades are the same thing?
Does this apply to jeep Cherokee CRD DIESEL 2012 as well ?
Do you the ohms for the fuel sending unit?
Can a fuel pump be weak but operating, i have a p0171 code and have went thru everything else.
very helpful thank you 🙂
can we bleed pressure of the system by removing the fuel pump relay and crank the vehicle? without using the pressure gauge system?
awesome guide, thank you…
What size bit Is that to remove seat
I leave my car without battery 3 days. and now no show fuel level, and only show de compass in the panel… no light configuration, no permomance, no K/l … what can I do ?
regards
So how do you clean out your tank with this type of pump? Or is the opening big enough to get your hand inside and you just siphon out again?
the pump is not sitting into position? ?
Do I have to take out the gas to put in the new fuel tank?
where's the fuel filter
Is this the same for 2012 Jeep Compass?
Will this work still on my 07 caliber it's a 2.0 ?
greeat.thank you.
Where is the fuel pressure port located on the jeep patriot? Thank you for your awesome video!
what size are the retaining bolts for the back seat?
Had the tank dropped before i watched this…. thanks for all the help man!
Does a 2013 Jeep Compass have two fuel pumps? one primary and a secondary pump.
Hi, thank you for this great video. Can you please elaborate on the very last step? is bleeding the pressure after installation necessary? I've read in the service manual that you need the scan tool to pressurize the system, is that necessary as well?