Buy Now!
New CV Axle Shaft from 1AAuto.com http://1aau.to/ia/1AACV00127
1A Auto shows you how to repair, install, fix, change or replace broken, worn, or vibrating CV axles. This video is applicable to the 2008 Honda Civic.
🔧 List of tools used:
• Pry Bar http://1aau.to/ta8/1AXAA00020
• 17mm Socket http://1aau.to/tEj/1AXAA00015
• 19mm Socket http://1aau.to/thD/1AXAA00043
• 32mm Socket http://1aau.to/tp/1AAST00003
• Dead Blow Hammer http://1aau.to/tcT/1AXAA00091
• 1/2 Inch Breaker Bar http://1aau.to/tck/1AXAA00078
• Ratchet http://1aau.to/tzj/1AXAA00016
• Torque Wrench http://1aau.to/tf2/1AXAA00044
• Center Punch http://1aau.to/tae/1AXAA00055
• Hammer http://1aau.to/tcT/1AXAA00091
For More Info visit us at http://1aau.to/h/abp/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Why would you go through all of that work and not change the transmission seal while you have the drive shaft out?
Do you happen to know what the torque specs for the outer tie rod is?
Great video. I just got a 09 and these videos will be helpful as all vehicles are different
How do I use the prying bar?, when the car is just on Jacks.
is there any grease that goes in the splines? or does the tranny oil lubricate it?
I have to do this myself soon because my boot is leaking grease, I've watch a few videos on this particular job, and your video is by far the best! Thank you for all the clear camera angles!
What if it is stuck in the transmission
Great video guys step by step like every dam fix it yourself video should be made! Thank you guys so much!
Just an f.y.i for Civic Si owners, to remove the spindle you're going to need a 36 mm socket.
Can you give me the torque values ? I cnt hear it
How much is it for this job?
Do we gotta drain the transmissuon before pulling the passenger axle?
Is it the save for a 2014
Do we need to do alignment after change this CV joint?
this is the video to watch