In this video I do a step by step guide on how to remove & install a driveshaft/axle shaft in a Honda Civic 2005 model,
I hope you find the video useful.
Thanks for watching
Disclaimer:
GerardBurke is a qualified motor technician who has completed modules & courses in manual handling and all aspects of workshop safety. These videos are not intended to be used by anyone who is not trained and or qualified to carry them out.
Due to factors beyond the control of GerardBurke, I cannot guarantee against improper use or unauthorized modifications of this information. GerardBurke assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. GerardBurke recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of GerardBurke, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not GerardBurke.
){kind=link}
Really appreciate the video! Gonna give this a go myself, though the biggest job I've done on my car so far is an alternator lol. I'm predicting I'll get about halfway through before I realise how far out of my league I am and send it to the garage.
Is the new shaft not missing a harmonic balancer in the middle. If I understand it right?
Was wondering if thats a drive shaft for 2005 honda accored to as well
Would this axel r&r compare to an ep3(2002 si Honda)? I’m doing one myself in the next week. Thanks for the upload thanks in advance for any response
Hi mate, I have this issue with my 2003 Honda Civic how much would someone charge roughly for the labour of this job? It’s an old car, and I’m unsure if I’d be better off scrapping it.
Thanks for the vid