Today i install ARP headstuds and head gasket getting ready to turn up the boost soon!
EBAY TURBO KIT USED IN VIDEO : https://www.ebay.com/itm/Turbo-Kits-D-Series-for-D15Z1-D16Z6-D16Y7-D16Y5/230958468950?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Did you cut and reweld that downpipebto get your ac back on? If so any advice on that? I have the exact setup and plan on doing the same to keep my ac, thanks
Good vid but first thing I noticed is your left hand should not be holding the torque wrench like that, it increases the ft lbs past where the wrench is set for a little bit, and always have everything lined up at top dead center before taking off t-belt.
It sounds like your still loosing compression by how the car started or your timing is off a tad bit.
I want to buy that same turbo for my honda civic d16y7
Would it be a good idea?
the air conditioning if it can operate?
What recommendation do you give me?
Did you burn the cylinder head gasket with the turbo?
or how did you burn the package?
Una pregunta le quemaste el empaque te culata por el turbo????
Bro I forgot to put my dial pins in. I haven't finished yet. But is it necessary or nah. Cause I already sprayed my gasket down with copper and put the new head on. Haven't tightened anything down to spec yet. So my question is if its necessary? I'm pretty sure that the gasket is already stuck on it
Im going to do the same type of build thanks bro its helpful
How did you know you needed a head gasket ? What were the symtoms ?
Is ur channel monetized ?
HeadER not headers, you only have one head on your car my man but honestly for it being your first head gasket job you didnt do too bad my boiiiii lol keep working at your craft my dude you can only get better
Put a vtec head on it go z6
Do.you have the link to buy these studs man?
You are gonna blow up soon if you keep it up
Why not upgrade the whole engine? (forged internals, etc)
Great job man
Nice job man. I’m not a big fan of the copper spray but to each his own.