Buy Now!
New Wheel Bearing & Seal Kit from 1AAuto.com http://1aau.to/ia/1ASHS00841
If you hear a grinding or groaning noise while your vehicle is rolling, it might have a worn out wheel bearing. A worn bearing can allow the wheel to wobble, creating a host of other issues. To save yourself from more headaches down the road, replace your bearing right away. For solid rear axles, you’ll need to replace the axle seal too. This video shows you how to install a new TRQ wheel bearing and axle seal on your 1988-2002 GMC K1500.
• Check here for more videos on the 1988 to 2002 GMC K1500 Sierra: https://www.youtube.com/playlist?list=PLJVpHWuCEUX82IMJQQ2BJVfv1GZfau7Mp
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
Top notch vid!!
Where can I find the torque specifications for that 8mm bolt holding that locking pin in. Have a 95 chevy c1500 don't have the owners manual for it
I have a Chevy C1500, 200,000 mi, showing some sign of seals giving out. Do you have to replace bearings also, or only if they're showing damage? Differential's always been well cared for, drained on schedule.
Great video. I have been a tech for 10 years and I have honestly never had to do a bearing, just a seal. Didn't know you could get that attachment for the slide hammer. looks like I will be talking with snap-on this week lol
Still want to know the size of those punches you used on the install
Where can I rent that tool?
Great video!
what size is that punch tool you are using to reinstall the bearing?
Well explained video, thank you.
Your video was really good except for you left out the part about removing all the breaks which is a major deal for some people
Good Vid. Thank you