HOW TO INSTALL A FUEL PUMP IN A 2002 GMC Yukon

HOW TO INSTALL A FUEL PUMP IN A 2002 GMC Yukon

DIY – FUEL PUMP REPLACEMENT
Before you start
1. Relief your fuel pressure by removing the vehicle’s fuel cap
2. Disable the vehicle’s electrical system by disconnecting the negative battery cable
3.Place wheel chocks in front of the front tires to prevent roll aways.
4. Raise the car
5. Support the gas tank with your jack
6. Loosen gas tank straps, and disconnect the fuel hoses from the fuel tank and module.
7. Remove the filler hoses from the tank.
8. Lower the gas tank,

18,363
Like
Save


Comments

Rob Beck says:

We’re not little kids don’t need the music it sucks

KIM ADAMS/WATLINGTON says:

how did you wire it up

Cars And Drums says:

Could've really done without the music lol

Ali Saleh says:

Is airtex good fuel pump ?

Larry Leisuresuit says:

then you get to figure out why the check engine light keeps coming back on. happy searching.

Riley Nash says:

But… The video is 7:41 seconds……. Not 5:00

Reply to Cars And Drums Cancel reply