Car Fix DIY Videos

https://amzn.to/46mW0jn – Power Stop 17-1707, Z17 Rear Ceramic Brake Pads with Hardware
https://amzn.to/3CLR6yU – Power Stop AR8658EVC rear Evolution Genuine Geomet® Coated Brake Rotor
https://amzn.to/3JzOQ1x – Permatex 25210 High Strength Removable Threadlocker
https://amzn.to/3r4KEQU – LOCTITE 243 Threadlocker for Automotive: Medium-Strength, Oil Tolerant, High-Temperature
https://amzn.to/3KrWMmH – Versachem 26080 Synthetic Caliper Grease
https://amzn.to/3ZcxkFZ – Permatex 80078 Anti-Seize Lubricant
https://amzn.to/3Ns9cuI – Permatex 80653 Silicone Extreme Brake Parts Lubricant, 8 fl. oz.
https://amzn.to/3PqLp11 – Milwaukee 2560-20 M12 FUEL 3/8″ Extended Ratchet (Bare Tool)
https://amzn.to/3XqNWKt – Milwaukee 2767-20 M18 FUEL High Torque 1/2″ Impact Wrench with Friction Ring
https://amzn.to/2VQD4qA – GearWrench 3/8″ drive torque wrench 10-100 ft. lbs 85062
https://amzn.to/46n8pE3 – GEARWRENCH 1/2″ Drive Micrometer Torque Wrench 30-250 ft/lbs. – 85066
https://amzn.to/3onFize – Rotor Remover 9000 short version
https://amzn.to/3q0yXuc – Rotor Remover 9000 with the longer wood handle
https://amzn.to/42X2VNm – OEMTOOLS 25265 Disc Brake Pad Spreader, Piston Brake Caliper Compression Tool
https://amzn.to/3JzP5JZ – Wire Brush for Drill Set 7 Pcs
https://amzn.to/3JqY0x9 – CRC Brake Cleaner

Just a quick video showing how I changed the Rear Brake Pads & Rotors on a 2016 GMC Sierra 2wd 5.3L. This would be the same for the Chevrolet Silverado, Suburban, Tahoe, Yukon, and Escalade and many other GM vehicles.

Tools needed:
13mm socket and/or wrench
18mm socket and/or wrench or breaker bar for caliper bracket bolts
You may need a large impact wrench to help remove these…
Caliper Wind back tool to push the caliper piston back in.
A ‘C’ – Clamp or Large Channel Lock Pliers tool work fine too.
Torque wrenches
Wire brushes or wire wheel on a drill
Anti-Seize
Brake grease
Thread locker
Small Sledge Hammer (may not be needed)
M10 x 1.5 Bolts to remove the rotor (may not be needed)
The torque specs I found online are:
148 ft. lbs for the caliper bracket bolts
38 ft. lbs for the caliper slide pin bolts

Thanks for watching!
Please Subscribe!
-Dan the Fix it Man
www.danthefixitman.org
Song used in the video:
‘I Had a Feeling’ by TrackTribe

This video is intended for entertainment and informational purposes only. Any repairs you make are your responsibility. I am not liable for any damages to you or your vehicle or your property.

As an Amazon Associate I earn from qualifying purchases.