how to replace the output shaft seal ford ranger 01

how to replace the output shaft seal ford ranger 01

how to replace the output shaft seal ford ranger 01 video about replacing oil seal shaft seal output seal ford ranger 01 02 03 01 00. automatic transmission. 2wd ford ranger. this shows you how to remove the shaft and the seal repair replace remove change cambiar quitar reemplazar reemplasar. transmission shaft seal replacement, transmission seal replacement. transmission output seal replacement.
Honda civic Toyota chevy Nissan Isuzu mazda truck pick up.

106,794
Like
Save


Comments

D M says:

It was very intersting for me, a lot of thanks

Yeud Siegal says:

Do you grease the output shaft teeth?

D M says:

Excellent video, it is good work !!!

Gabriel Hernandez says:

Do you have a fkn forklift holding your car up? Haha

jpnm81 says:

I like it straight to the point

WorldRenownedCFE says:

use rtv gasket maker sealer around the new seal because they slip out sometimes, but good luck trying to get the old one out. it isn't this easy.

Roel Cassiano says:

I hope this helps someone, I bought an output shaft seal and at the end of the video he just slides It in with his hands and the lip of the new seal is flush with ring around the output shaft well I tapped it in and it just sat in the hole as it's not getting pressed in, it kept falling off and so I just Gorilla Silicone and a good amount and put it around the lip to stick onto the ring and it sealed liked that, no video really says anything about silicone so I hope this helped you

Chris Durnin says:

A new seal will not just pop in like that, I'm literally laughing out loud

Neai Tuppi says:

That is definitely something I could not do, was pop the new seal on like that.

Neai Tuppi says:

Disturbingly, my seal appears to be completely gone.

CobraR1993 says:

Very dangerous to work under a car held up by a forklift!!

Mauricio1766 says:

Have you ever changed a rear oil seal on a eaton fuller manual transmission?

Comments are disabled for this post.