Buy Now!
New Exterior Door Handle from 1AAuto.com http://1aau.to/ia/1ADHE00630
1A Auto shows you how to repair, install, fix, change or replace a broken or snapped off passenger exterior / outside door handle. This video is applicable to the 98, 99, 00, 01, 02, 03, 04, 05, 06, 07, 08, 09, 10, 11 Ford Ranger
🔧 List of tools used:
• Rivet Gun & Rivets
• Drill
• Drill Bit Set http://1aau.to/oE/1AXAA00141
For More Info visit us at http://1aau.to/h/bsr/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
What if the handle works but the door still won’t open? I pull the handle on mine and it opens about 2 inches and stops.
Does 1A Auto sell the cables for the rear door on a 2001 Ranger? If so please provide a link, thank you.
FYI I wouldn't do this job without also getting the cable repair kit my door handle turned out to actually be fine the plastic cable ends all I needed dorman part #926-111 the replacement is aluminum
What size drill bit should be used?
Excelente. Muchas gracias por el video
What size pop rivet did you use to reassemble?
Nice video. I thought these were tamper bolts lol. Drilled them out just like video no problem.
warning, the removal of the handle isn't anything close to whats shown on the video.
the rivets are nor flush like the video implies, rather, they extend out, enough that it is impossible to keep a drill centered on it by hand.
expect the drill to slip off the cebter, then get caught and probably break, drill into the trucks sheet metal because not centered, etc
addirionally, as you get closer, the rivets will also start spinning, causing friction and melting the plastic handle assembly. you will need to use some kind of chisel or small screwdriver to wedge under the rivet, to hold it and keep it from spinning.
in the end, expect a bit of a mess – enlarged sheetmetal holes from the off centered slipped drill, and scratched/dented sheet metal from the other tools required, such as screwdriver/chisel wedge to hold the rivet still.
What size rivet is needed to re-attach door handle?
My plastic peace on my wire drie rotted on me any help plz