How To: Subframe Replacement On Dodge Charger/Challenger!

How To: Subframe Replacement On Dodge Charger/Challenger!

How to remove and replace a subframe also known as engine cradle in a dodge charger or challenger hellcat. This guide also works for most if not all Chrysler LX platforms such as the Chrysler 300, older chargers and challengers.Car Videos.
—Support The Channel—
Buy Corsa Extreme: http://amzn.to/2gwad9c
Buy Corsa Extreme: http://bit.ly/2wuX5W4
Buy JBA Catless Downpipes: http://amzn.to/2u698v5

—Buy Other Misc Stuff—
Buy Pipe Expander: http://amzn.to/2vkWZlD
Buy Female Torx: http://amzn.to/2wnQ8ES
Buy Oxygen Sensor Tool: http://amzn.to/2vrrhD3
Buy 22mm Wrench: http://amzn.to/2vkuO69
Buy Jack Stands: http://amzn.to/2wnK7b9
Buy Jack: http://amzn.to/2u2MmjF
Buy Ramps: http://amzn.to/2wnzu8q

—Support the Channel Purchase From Links—
Tire Rack: http://bit.ly/2sE9nrQ
Amazon: http://amzn.to/2rE1Dd4
Goodyear: http://bit.ly/2uipobC
Auto Zone: http://bit.ly/2uixz7y
CarID: http://bit.ly/2x2WeLp

*Music licensing by Triple Scoop Music
http://TripleScoopMusic.com

31,883
Like
Save


Comments

Eli Zelk says:

Hey guys, I have a 14 RT charger, when I turn my wheel hard to the left and then left off the brake, I get a clunk from the d/s.. I have new strut tensioners, new inner and outter tie rods, new upper control arms, the noise didn’t start until I got my last alignment.. any ideas what could cause this? It’s only low speeds hard turn on the wheel and only going backwards..I though maybe sub frame bushings but I don’t think that’s it..I think it has something to do with the tension strut..any advise is greatly appreciated.

Marquarius Fuller says:

So how many bolts it is in all to uninstall subframe ??

BLUE HULK says:

Curious… Did you take the damaged subframe back to salerno duane? I'd think they'd need to reimburse you for that hack job.

Hookset Tech says:

you didnt show the only part i need help with. using the top side engine cradle where do you hold up the engine from? i have all the tool gut everything in the area is too small or plastic.

Alex says:

Hey man, great video.. Have you ever experienced alignment issues in your charger? Just had the lower control arm and tie rod replaced because of excess tire wear on the fronts but they cant get it realigned. They say i might need a bolt kid or camber kit or someone online mentions an adjustable upper control arm..

Jason Townsend says:

is the 2004 dodge neon SRT-4 2.2 turbo a sub frame, full frame or a uni body?

Phillip Spain says:

Would you have to disconnect anything strut/shock related?

Hack Er says:

great video your right couldn't find anything else out their hella thanks im getting ready to do the k subframe on my 07 300 I know this question has been addressed but else understand im not the brightest bulb, ' HOW IS THE MOTOR SUSPENDED?? " I realize from the top, just wanted to do it the same as you did so that I have no problems like you didn't. thanks again for the video and keep up the good work.

JAI M says:

That clown video taping everything talks too much

Eric Richardson says:

I have a 2005 dodge magnum rt..I'm replacing my subframe as well because of extreme rust and cracked…have a new subframe but where can I purchase the bolts?

maryann schmidt says:

Great video! Question: Dodge replaced my steering column in my 2016 Charger last year under warranty, to do that did they have to drop my subframe? The reason im asking is that I recently noticed that my passenger front wheel is not centered under the fender(its pushed to the rear about 1/2 inch). I dont see any suspension components bent or broken so im guessing either the subframe is slightly bent or possibly it can be slightly adjusted? …. Just kind of fishing at this point to figure out whats going on and best options to get it corrected …. I do recall hearing a "clicking" noise a couple times from that general area of the car after they replaced the steering column but havent heard it or noticed it lately and car seems to drive fine with the wheel slightly off center but of course I want to get it corrected. Any info is appreciated Thanks!

Comments are disabled for this post.