How to Replace Output Speed Sensor 04-09 Dodge Ram

How to Replace Output Speed Sensor 04-09 Dodge Ram

Buy Now!
New Speed Sensor from 1AAuto.com http://1aau.to/ia/1ATRS00309

1A Auto shows you how to remove, install, change or replace a rusted or defective ABS wheel speed sensor. This video is applicable to the 04, 05, 06, 07, 08, 09 Dodge Ram truck.

🔧 List of tools used:
• 8mm Socket http://1aau.to/oxE/1AXAA00017
• Ratchet http://1aau.to/oIE/1AXAA00016

For More Info visit us at http://1aau.to/h/ahp/

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

113,546
Like
Save


Comments

1A Auto: Repair Tips & Secrets Only Mechanics Know says:

Watch the Video

Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto

Do it Yourself

Save Money

Elder Grief says:

I have a 2012 ram 2500, it reads overdrive sensor switch. Where is this located, and is it a speed sensor switch?

Ezequiel Lora says:

Same sidee have 2 sensor same what is

Jesse James says:

Would this fix a p0876 on a 2003 ram 1500 4.7? I changed the one on the rear axle and the one on towards the back of the teansmission

adrian white says:

Will this the same for an 03 1500 with a 45rfe?

Joe Cranfield says:

Any need to reset the tcm after the swap?

VFRrider25 says:

Would this fix the P0700 and P0734 codes that make the truck go into limp mode?

VFRrider25 says:

My ram 2500 is in limp mode with codes P0734, p0700, p1684–will this fix it?

Maurice83 says:

I got a 2012 ram and my output speed sensor is gone. The dealership tells me it's a 5 hour job because the bolt will always snap off holding it in.

Dana Stryker says:

This video is the same as your out put video.

J G says:

You confuse people when you say wheel sensor

Jason Vylasek says:

I know this video is old, but I’m hoping I can get a response from someone. Would it be the same location on a 2013 ram 1500? Any help would be appreciated. Thank you

Gregg says:

Wow, look at all the wonderful rust! It looks just like my Dodge. My 06 530i BMW has given me no problems over the past year, my 06 Dodge Durango has cost me $5,000 so far! If you can, avoid these cars and trucks! (D)ead (o)n (d)elivery (g)o (e)lsewhere!!!!

trafficjon400 says:

i replaced sp s it did not do the job

Richard Godin says:

i got a.98 ram 2500 .. my speedometer stop woking and it wont chift out of first gear would that senser be the problem

Asari Burk says:

Would it be in the same place for a 2004 dodge Dakota? Also would that replacement of the sensor turn off the abs and brake light on the dash board?

chris2crazzy says:

So I'm guessing this controls shifting at the correct times? Keeping it from shifting too soon

John Mccloud says:

Does this affect rpms

Austin Piper says:

would that fix a vehicle from bogging down on turns

Comments are disabled for this post.