Car Fix DIY Videos

Buy Now!
New Control Arm with Ball Joint from 1AAuto.com http://1aau.to/ic/1ASLF00610

This video shows you how to install a front lower control arm on your 2002-2008 Dodge Ram 1500. Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear, or integrated ball joints that require replacing the entire arm when they wear.

This process should be similar on the following vehicles:
2002 Dodge Ram 1500
2003 Dodge Ram 1500
2004 Dodge Ram 1500
2005 Dodge Ram 1500
2006 Dodge Ram 1500
2007 Dodge Ram 1500
2008 Dodge Ram 1500

Tools you will need:
• Pry Bar http://1aau.to/oQY/1AXAA00020
• 10mm Wrench http://1aau.to/oTz/1AXAA00010
• 16mm Wrench
• 21mm wrench
• 24mm Wrench
• 18mm Socket http://1aau.to/oac7/1AXAA00043
• 21mm Socket http://1aau.to/oac7/1AXAA00043
• 24mm Socket
• 35mm Socket http://1aau.to/oak/1AAST00005
• Torsion Key Unloading Tool
• Trim Tool Set http://1aau.to/o7I/1AXXX00006
• Side Cutters
• 7/8 Inch Socket http://1aau.to/obr/1AXAA00042
• T60 Torx Socket
• Torque Wrench http://1aau.to/oazD/1AXAA00044
• Anti-Seize Grease
• Block of Wood
• Bungee Cord
• Gloves http://1aau.to/oVX/1AXSS00048
• Marker / Writing Utensil
• Safety Glasses http://1aau.to/oPa/1AXAA00343
• Floor Jack http://1aau.to/oZg/1AXAA00068
• Hammer http://1aau.to/oRY/1AXAA00091
• Pole Jack
• Sledge Hammer http://1aau.to/oRY/1AXAA00091
• Wheel Chocks

Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.