How to Replace Blend Door Actuator Dodge Avenger. Clicking Tapping Noise in Dash Fix. Actuator locations. Dodge Chevy Ford Blend Door Actuator Replacement. This video will show you the location of all three blend door actuators on this dodge avenger and many other dodge ford chevy and many more vehicles. I will show how to properly remove and reinstall the vehicles blend door actuator. Will also show you how to diagnose which of the actuators have failed. This vehicle clicks everytime that the door is opened and when u turn hot cold knob.
I assume no liability for anything you choose to do to your own car. All Repairs you perform to your car are performed at your own risk.
Could a bad actuator cause no heat? Or very little heat?
Mine does the sound on driver side
Hey man! I replaced the heater core and the heat got a bit hotter on the driver side. Yet, the passenger side is still very cold. Non of the blend doors are making noises, but I believe that they may be faulty. Can they fail without making noises? If not, what do you think is wrong? Thank you in advance man
Where do i buy the bling accessories? I have the same car and love the bling!
Excellent job sir.
this has been very helpful you the man keep up the good work
Is this the same for a chrysler sebring?
so does it eventually cause no heat. i used to hear the clicking every now and then now i have no heat in any vents air works fine
My daughter's car is making a similar sound in her 2011 Dodge Caliber. It does it even if the air is NOT on. Could it still be the actuator if it makes the sound with air off. She hears it loudest in reverse.
https://www.rockauto.com/en/catalog/dodge,2009,journey,2.4l+l4,1444145,heat+&+air+conditioning,heater+blend+door+actuator,10721
Do you have the part number, I partially saw a number on the video but could not make iut the last few digits
Just tape the new one over the old one. Getting your hands in there is a pain
WHAT IF I HAVE NO HEAT BUT IT IS NOT MAKING THAT NOISE? COULD THIS STILL BE THE ISSUE?
you've saved a lot of people a lot of money… thank you!
Would this apply to a 2010 Sebring also ? And should I disconnect the battery ? Thanks
Well done video. Very helpful.
So what does the actuator control?
My doors have to be locked by hand and my trunk release button won't work
How did you install the actuator arm?does it go on one way?
You are very, very good at making these videos man. Great job and thanks! I was able to fix this issue for my girlfriend in about an hour with your video as a guide.
Awesome, thanks! I just brought a used 2014 Avenger yesterday and didn't notice the sound until after the purchase. Anyway, it doesn't look too urgent of a fix and the part on Amazon is only about $18.00. It just looks difficult to reach.
Do you have to attach the arm part on the passenger side ones too ?
The clicking sound is similar to what I heard this morning when I started my 2014 Dodge Avenger. Would I be able to locate the actuators in the same locations?
Is it the same part for all three locations, because mine is doing it it two places
My Chrysler Sebring 2010 has the same clicking noise, not sure if the blend door actuator are located on same location as outlined in the video ?
Thanks for making this video, very helpful,
I hear it when I unlock the car & sometimes when I mess with the AC. Is it dangerous not to fix?? I just plan to get rid of the car in 4-5 months & have already put so much money into this car that I rather just not do anymore fixing.
It just started a month ago & I hardly drive the car.