For More Info visit us at: http://1aau.to/h/wN/
1A Auto shows you how to repair, install, fix, change or replace a broken, damaged, cracked, faded, cloudy, or chipped signal light. This video is applicable to the 05, 06, 07, 08, 09, 10 Chrysler 300
This process should be similar on the following vehicles:
2005 Chrysler 300
2006 Chrysler 300
2007 Chrysler 300
2008 Chrysler 300
2009 Chrysler 300
2010 Chrysler 300
🔧 List of tools used:
• Gloves http://1aau.to/oa8/1AXSS00048
Subscribe: https://www.youtube.com/channel/UCVvE8kQTuZEykvMFZBVzftg?sub_confirmation=1
Check out our playlist:
Chrysler 300 2005-10 1st Gen: https://www.youtube.com/playlist?list=PL37d7oWG6wDBMr60VGh-39gda1W1cvHdM
For More Info visit us at http://1aau.to/h/wN/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
Well I did what you said: pushed on the inside but the other part snapped!
1.) this video demonstrates the RIGHT side light. [the LEFT is MUCH HARDER due to cold air intake in the way
2.) i did NOT have to remove the belly pan
3.) i was able to change the bulb by ONLY turning the car's wheel inward as far as possible, and removing the THREE closest wheel well speed fasteners. I was able to flex the wheel well plastic panel enough to get my hand/arm in there, 1/4 turn the light socket out of the back of the lens/reflector assy , and pull the socket out just far enough to be able to pull the socket and attached wire out from behind the bumper/wheel well, pull the old bulb out, and put the new on in the socket, and put it back in, and reattach it with a 1/4 turn.
4.) the drivers side is much harder. had to remove some module that was attached to the bumper just inside bumper behind/in front of the wheel well (1 10mm bolt). But it's REALLY hard to maneuver your wrist/arm with the intake in the way.
Also, the video above shows that the light lenses just pop out of the fender — FALSE — there is a NUT/STUD that holds them in on leading edge. Assuming a stock car with no damaged/missing nuts/studs, you will NOT be able to just press the clip in and pop it out.
Anyway.
Was there water in that side marker
HOW DO YOU CHANGE THE SIDE MARKER BULBS ON A 1990 CHRYSLER 5TH AVE?
Can you show how to take off and replace the front side fenders ?