How to Replace Ignition Lock Cylinder 1988-2000 Chevy C/K1500

How to Replace Ignition Lock Cylinder 1988-2000 Chevy C/K1500

Buy Now!
New Ignition Lock Cylinder from 1AAuto.com http://1aau.to/ia/1AIMX00039

This video shows you how to repair, install, fix, change or replace a broken, damaged, worn or faulty ignition lock key cylinder in your 1988-2000 Chevy C/K1500.

• Check here for more videos on the 1988-2002 Chevy K1500 http://www.youtube.com/playlist?list=PLJVpHWuCEUX8H3TYrfqfxS63cPmr-AhVw

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

32,502
Like
Save


Comments

TRQ says:

Watch the Video

Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts

Do it Yourself

Save Money

Lora Wriggle says:

What is the 1st plastic piston u press into tumbler. Truck won't start after replacement of tumbler

adam parra says:

I broke the piton that you remove right after the hazard switch what is it called so i could replace it

Greg Bellinger says:

Very good video and commentary. Thanks.

The Grey Yota says:

Where can i get the clip that holds in the plate mine its bad and i cant find one

Haolyphotography says:

What happens if I have a lost key. Is it not possible to do this without the key?

Marquaris Smith says:

The tool he used is called a lock plate removal

Clay Jeffress says:

Awesome video…. Very instructive…. VERY thorough on EACH step. This had for to be the best… How to video …I've seen so far.. Great job ….. But I did notice if someone has a ? No one responds…. Why would they.. lol… The video covers it….

Terry Clapp says:

Although it is not mentioned in the vid, at some point I noticed you dropped the steering column. Is this necessary for the process in some way?

Cristobal Hernandez says:

What the tool your using to push it down called

TheWest400 says:

Thanks man I needed this

Comments are disabled for this post.