http://www.1aauto.com/1A/fog-lights/Chevy/HHR 1A Auto Shows you how to install, repair, fix, change or replace a broken, damaged, burned out, cracked, faded,…
How To Install Replace Fog Light Chevy HHR 06-10 1AAuto.com
15
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
I just installed figlights on my 2011 chevy hhr. Ut wasnt equipt wuth them but what i did was connect them to the quarter lights the orange ones and work awesome. Uf anyine needs any info email me at fcervantes3725@gmail.com
Thanks for watching. 1aauto.com 888-844-3393
Mike – BRAVO! Well done – thanks so much. I just ran over some road debris late at night and whatever it was just thwacked the right fog light back into the area covered by the plastic housing secured by those pop pins. Good thing, or it would have all been ground up by the road. I think I’ll be ordering one anyway, since it does seem compromised. Thanks again – very helpful.
You can mark the adjusters as we show in the video, or before you change them you can pull the car up to a garage door or a wall and from 25′ away see where the fog light beams land, and use that as a reference when adjusting your new lights. Hope this helps you out.
When you adjust the fog lights what is a good guide to use?
If your vehicle wasn’t equipped from the factory with this option, you may need some additional wiring. If you want a factory install, you could ask the parts department at your local dealership what additional things you may or may not need to complete the install. You could also look for an automotive forum for your vehicle, some of the members may have enabled this feature.
please show us how to install not replace for those people the have the just the plastic insert and please show us where to put the switch thanx 🙂
hey man
can u show the replace fog light from a chevy spark? “2011”
I did this, although I had to take out a few more of the plasti-clips and screws to get better access. Thanks again
awsome tutorial, clear and to the point! I’m so glad I don’t have to reinvent the wheel.
Peace
Gill
I just want to say thank you.
Anything is possible 🙂 Mounting the lights is not a problem as I believe the cars just have filler panels where the lights would be. The problem might be the wiring. The cars may be wired already but if not you will need to wire a switch in the car. GM may sell a kit to do all this and make everything look factory.
is it possible to instal fog lights in an hhr that didn’t come with them?