How To Install Repair Power Window Regulator Chevy Monte Carlo 00-07 1AAuto.com

How To Install Repair Power Window Regulator Chevy Monte Carlo 00-07 1AAuto.com

http://www.1aauto.com/1A/WindowMotors/Chevy/Monte-Carlo/1AWRK00037 1A Auto shows you how to repair, install, fix, change or replace a broken, cracked, damage…

34
Like
Save


Comments

1aauto says:

If it’s a cable regulator and the cable is bound up, you would need to free the cable up in order to enable the window to slide down. Hope this helps you out. Have a great day! 1aauto.com

chrisn817 says:

i cant take the regulator off because the window dont roll down, what do i do??

dabruin54 says:

This video is excellent for DIY’s. I saved $300 by avoiding a repair shop. Thanks for the website. Will use it frequently.

MrJimmyPat says:

Well done vid. Thank you

1aauto says:

You could try to spray the rubber weatherstrip around the window with a silicone spray to help speed it up. You could also put some white lithium grease on the window regulator track too. Hope this helps you out.

Cedric Hunter says:

I have 2004 Monte Carlo SS Supercharged. On my driver side my window will go down fine but it wont come all the way back up. I have to guide it with my hand and even then it’s not in there good cause I can hear wind while I drive. What should I do?

1aauto says:

Thank you for checking out our auto repair channel. We carry new window regulators for your Chevy Monte Carlo on our website. Here’s a link to them if you would like to check to see what we have to offer. 1aauto.com/1A/WindowMotors/Chevy/Monte-Carlo?utm_source=youtube&utm_medium=youtube&utm_campaign=1ATony

HazardousVids says:

Thank you so much for this video. We just had our passenger side window regulator fixed and two weeks later the driver side window fell. Thanks to you though for making this video I was able to do a temporary fix using two 2 X4’s until I can buy another regulator. (this is especially good since it may rain on friday).

A J says:

I drive a 2001 Monte Carlo. The window regulator has been breaking on a regular basis due to poor design. I have been shelling out $350 to get it fixed at auto shops. I always hated that since I’m very handy. This video boosted my confidence and today I did it by myself, doing so I saved $210. Thanks.

Sameer Sharma says:

Thank you for making this video. I have ordered parts from you as well. so cant wait to replace my window.

305Navi says:

Thx for the vid. I’m going to work on my 02″ MC first thing 2morrow morning. This vid helped me a lot cause a was seriously thinking about having the dealer do it for me but after watching ur vid I can actually do this myself. Thx again

Write a comment