Chevy Cruze / Sonic Lowering Springs Install DIY – B&G, Eibach, H&R, Vogtland

Chevy Cruze / Sonic Lowering Springs Install DIY – B&G, Eibach, H&R, Vogtland

In this video, I will show you how to lower your Chevy Cruze on new lowering springs. This will be the same for any brand spring for the Cruze.

Tools needed are listed in the video.

17,121
Like
Save


Comments

Calvin25X says:

Can you lower the back so it looks more aligned with the front rear?

Overtourr says:

Did you see any increase in cornering performance of cruze

what4 fsk says:

I have 18" rims on mine would they be a problem lowering it ???

Cruze Eli says:

Was this your first time putting springs on a cruze?

GrnArrow092 says:

I've got a 2014 Cruze LT. I've been toying with the idea of possibly lowering my car and I never imagined how easy it is to do. I only wondered was if you had to take your car in for an alignment after installing the new springs.

Levy Hernandez says:

15/16 Deep Offset Wrench I just got one from Sears!! Cruze owner having the right tools if a must!! Trust me I know!!

Daniel R. Galindo Huaman says:

you have to drive for the springs to settle, it actually will lower a little more.

Baba Yaga says:

Hello . Will the lowering springs for cruze fit with the sonic?

Anthony says:

I just copped some GodSpeed lowering springs I can’t wait to install them

PedoLeem says:

Did this on mine and the only huge issue I ran into was the part wit the T40 (the first step) after doing it all and putting it back it was almost impossible for me to get the T40 in without stripping it to hell.. any advice? It’s still a little loose so I’m refraining from driving far.

Eric Byrnne says:

Hey Chad, great video…can you tell me the size of the tires you had on when you made this video please? Thank you

Brad Tyler says:

Did you have to get an alignment after install?

don_ cruzen says:

Bro i just installed eibachs on my 12 lt rs and its like its on coilovers. Seriously. Barely to no fender gap in the front

Bryan Cordell says:

Hey how did you get the top nut off oil running into the same problem

christian duron says:

Would this fit my 2016 cruze lt?

Austin Fate says:

Thank you so much!!!! Just finished and couldn’t have done it with this

moises garcia says:

Did the front end settled down more after all?

Clean Cruze says:

Hey just letting you know your video helped me a lot I did my car today!!!!!

Maritime Law says:

Do you know how much it would cost to get it installed?

Richard Hein says:

Hey what springs do you use to lower your car?

Comments are disabled for this post.