Rust repair on a 1972 Chevrolet C30 Truck C10 C20 C30 K10 K20 K30 C2500 C1500 C3500 GMC Ford Dodge Mack International Toyota Mazda Rocker Panel Rust Bucket C…
Rust repair on a 1972 Chevrolet C30 Truck C10 C20 C30 K10 K20 K30 C2500 C1500 C3500 GMC Ford Dodge Mack International Toyota Mazda Rocker Panel Rust Bucket C…
You must be logged in to post a comment.
glad to see you protect your ears!
loved the air compressor camera angle. sick
Great job! Sorry I clicked dislike by accident because my volume was set
way high and I am at work, panic attack, meant to mute it.
check out my rocker panel install
Great video, funny as hell to! The guy doing the work sounds like the guy
off of cocktail!
@nufsed777 try lmctruck.com
LOLOLOLOLOLOLOLOL NICE SHORTS
hello im from Argentina , i have the same truck c10 1971 and i have to do
the same work. all in the same part of yours. je je . very good job from
Argentina.
hey im restoring a 78 k10 and i pulled the rcker off only to find ut that a
littial bit further back there is a hole through the floor and was
wondering hw i should go abut fixing this…shuld i weld the inner rocker
and rocker in then fix then put a new floor pan in or should i put the
floor pan in then weld the rockers plz reply im stuck
Should have put some music to it but I still love it. Great job.
lol
2:54 what the hell was that
that guy is crazy. but that is why he is so good. he’s crazy good
its great to see a couple of buddies doin a tough job and not gettin pissed
about the small stuff plus very helpfull info where is the best place to
get those patch panels ive got a 71 gmc im doin this spring not as bad as
yours but piss poor past repairs thanks again you guys were a hoot
wait ! Question. Is he crazy because he is good? Or is he good because he
is crazy ?
yappa yappa haha nice vid, and nice shorts
I bought the patch panels from classic parts. I opted for the less
expensive panels and did not go with the NOS GM panels. They all fit pretty
good except for the drivers floor, it was way off but still usable. You
could also get em from Brothers or LMC. They all sell the same crap, or
spend big bucks and get GM stuff. In my case the rockers fit well and were
high quality for little money. If you really want to be sure join a truck
club and find out where to get the best stuff. dave….
you guys are pretty funny. subscribed