How to Replace the Fuel Pump on a 2009 Buick Lucerne

How to Replace the Fuel Pump on a 2009 Buick Lucerne

Brian Eslick from How to Automotive takes you step-by-step through the process of replacing the fuel pump on a 2009 Buick Lucerne.

Affiliate link mentioned in the video for ACDelco MU2171 GM Original Equipment Fuel Pump and Level Sensor Module http://amzn.to/2qjD7sI

Website
For more videos, tips, and to purchase recommended tools and products visit my website at: http://www.howtoautomotive.com/

Stay connected at:
Email: howtoautomotive@gmail.com
Facebook: https://www.facebook.com/How-to-Automotive-432536836946801/?ref=settings
Google+: https://plus.google.com/+HowtoAutomotive/posts
LinkedIn: https://www.linkedin.com/in/brian-eslick-819839118

Disclaimer
Owing to factors beyond the control of How to Automotive/Brian Eslick, it cannot guarantee against unauthorized modification of this information, or improper use of this information. How to Automotive/Brian Eslick assumes no liability for property damage or injury incurred as a result of any information contained in this video. How to Automotive/Brian Eslick recommends safe practice when working with power tools, automotive lifts, lifting tools, jacks and jack stands, electrical equipment, blunt instruments, chemical lubricants, or any other tools or equipment seen or implied in this video. Because of factors beyond the control of How to Automotive/Brian Eslick, no information contained in this video shall express or imply warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or information contained in this video is the sole responsibility of the user and not How to Automotive/Brain Eslick. #howtoautomotive #FuelPump

23,744
Like
Save


Comments

john1240able says:

How many miles on it.

Big Yungin says:

Thanks you so much for this video! Super helpful!

Yung WUn says:

is it the same for a 2008 Lucerne CXL?

Randy Banks says:

California emission pump?

Dakstang says:

It would have been very helpful if you had shown actually unhooking the lines and also the fuel sending unit. I had a lot of trouble actually getting the lines off. Also I broke the fuel sending unit because I could not figure out how to unhook it.

sethmeisterg says:

Thank you so much for making this video 🙂

robert r says:

you moving the camera way to much did you get high off the fims

R. A. says:

what a blessing you made this little vid

Kenneth Soriano says:

thanks for the info, Have a merry Christmas.

Kenneth Soriano says:

is it the same procedure on a 2007.?

Kenneth Soriano says:

is it the same procedure on a 2007.

Write a comment