In this video i replace the rear Bushing (Ball joint) on a Bmw 5 series.
Enjoy the video!
Check out Cody’s channel channel;
https://www.youtube.com/channel/UC7AtpaCPv1QXYa-yE2sPQbQ
For Business inquiries; Diagnosedan@gmail.com
Join me on Facebook!
I've never seen any tutorial so clear and professional as this one! Good job Dan and thanks!
For anyone doing this job on the ground, I had the best luck completely removing the swing arm. Then attaching to the new ball joint, then maneuvering the upper swing arm into place. It’s very difficult to reattach otherwise
Nice job yes it's always god to have the correct tools for the job great installation
I like your video y your knowledge
Hi Dan, I need you help
It's a fail but here in uk it might just pass
This is by far the best video I have found on this job, but, doesn't Dan own a torque wrench? All of those bolts/nuts need to be torqued properly, not just slammed on with an impact wrench.
realy good job.
Would it help to add a little heat to the bearing housing or/and cool the bearing itself in dry ice before starting the press-in procedure? A few thousandths of an inch can really make things easier.
Hi! Where you get the tool got remove the ball joint?
Air impact gun will help a lot…?
Hi Dan. I like your videos, really. You dont use torque wrench for specific torque of bolts? Thnaks
And do you have a link for ball joint tool?
What are the symptoms that this is bad
Good job Brother.
Can i just replace the entire control arm rather than just the bushing? Is it the rear lower control arm?
Great stuff but maybe a torque wrench? I love your videos. you present and film very well. thanks .
Diag Dan I would love to see more mechanical videos also, it's a pleasure to see pros at work. Keep up the good work. Al London On. Canada
Just a question .Rather than the spanner which takes ages, why not use power tool or even a ratchet spanner?