2008 Audi A4 2.0T
Front Upper Control Arm Replacement
Follow the vid and you should good! Thanks for watching!
Tools Used:
Kinda forgot so just pay attention to the video and you will be good as stated before. Thanks again!
2008 Audi A4 2.0T
Front Upper Control Arm Replacement
Follow the vid and you should good! Thanks for watching!
Tools Used:
Kinda forgot so just pay attention to the video and you will be good as stated before. Thanks again!
You must be logged in to post a comment.
That's a good editing style. If you can cut the length of video it would fire.
That bolt fought you hard. Makes me feel pampered doing auto repair in Cali.
Just subbed.i'm in so i can learn. From victorville,cali.
Trick for that top bolt you fought with is to heat the spindle a bit and then just use a 1/2 impact gun on the bolt and just let it spin (don’t pry on it or nothing) and the bolt self cleans itself and the hole it’s in and you’ll hear your impact gun slowly start to speed up until it gets to the point where your gun will spin at full speed, at that point the bolt just slides out
Great video thanks brother. I was expecting a one piece control arm. I think this is the first time I seen a two piece upper control arm. Keep up the great work see you in the next video thanks again brother. I learned something new today thank you
Your commentary is hilarious. https://www.amazon.com/gp/aw/d/B0002SRH7O/ref=mp_s_a_1_2?ie=UTF8&qid=1526005454&sr=8-2&pi=AC_SX236_SY340_QL65&keywords=otc+ball+joint+separator&dpPl=1&dpID=41apsehGOiL&ref=plSrch
Can you put videos up of Chrysler 300 3.5
Thanks for the video why do you not use acetylene gas ?