*Link for the parts*
https://www.ebay.com/itm/113392167454
https://vagrepaircenter.com/
Common problem with this module :
-Takes several attempts before car will start
-Steering lock fault code 00288 (steering lock actuator N360)
-Clicking noise when key inserted
-No ignition car will not start
-Vehicle immobilized
If you already managed to reset this error by EOBD diagnostics the problem will most likely happen again unless you change the parts supplied in this KIT.
DIY Job.
Anyone with basic knowledge and tools can desolder old and solder new parts. Just be patient and tidy.
If the module if from your car then NO ADAPTATION is required. Just put it back in when you change the parts.
If you have a situation where you don’t have ignition at all caused by this module then there is a way to reset it.
You need a VCDS and I can link you the procedure, no problem.
What ever problem you have with this module don’t put it back in as it was, because the problem will reoccur unless you change the switches and relay.
*Link for the parts*
https://www.ebay.com/itm/113392167454
https://vagrepaircenter.com/
){kind=link}
Good job! I had 00288 N360 "Steering Workshop Defective" fault on my 2003 Touareg. how can fix it. Can you help me?
Can you repair the Module for my 2008 Audi Q7. it won’t Start anymore after the Module was removed from the Steering Colum. The only problems was the Navigation stopped working and it has a periodic power drain.
Postovani kako uraditi ovo.isto.sa modulom koji se nalazi na letvi volana Audi q5.Prilikom prolsska kroz vodu,verovatno je usla koja kap i javlja gresku steering defective.
This is great the question is what needs to be removed to get to this?
Did this cause your car to not turn on?