Got the same car, you should have cut the air snorkel off of the oem filter box and put it back on the car. So it brings cold air from the front bumper to the filter.
i have a non type s.
if i want a K&N also, which one do you recommend?
i bought one recently and it didnt fit (im guessing i bought a type s one)
thanks
have the exact same one took 30 min tops. very useless md fun to do and it looks pretty. problems is the intake is acctually close to the headers so it takes in warm/hot air. but i do like the sound and look! good vid.
great video! i installed a cold air intake. and it helped me figure out how to remove the stock airbox and the ports. after that i was on my own though. the injen instructions weren’t exactly very clear cut. but hey i managed. awesome sound after. well worth the pain of installing it! :]
I just used this to help install a injen short ram-very close design-thanks,it did help me-injens instructions were pretty weak-but their intake is awesome!!!
Got the same car, you should have cut the air snorkel off of the oem filter box and put it back on the car. So it brings cold air from the front bumper to the filter.
i have a non type s.
if i want a K&N also, which one do you recommend?
i bought one recently and it didnt fit (im guessing i bought a type s one)
thanks
also the radio code apparently is on the inside of the glove box says honda
have the exact same one took 30 min tops. very useless md fun to do and it looks pretty. problems is the intake is acctually close to the headers so it takes in warm/hot air. but i do like the sound and look! good vid.
Can’t imagine it would be too difficult, but definitely some fabrication will be in order. Good luck 😀
How can i put a type s injen sri intake onto a base ?
Awesome video, I think is much easier to watch a DIY installation video, rather then looking at the manuel.
Glad I could help. For sure gotta love the growl it gives the k20. Have fun 😀
great video! i installed a cold air intake. and it helped me figure out how to remove the stock airbox and the ports. after that i was on my own though. the injen instructions weren’t exactly very clear cut. but hey i managed. awesome sound after. well worth the pain of installing it! :]
Ya buddy!
Damn good video!!! Will FOR SURE use this while installing my intake on Friday!
Glad to hear. Thx for watching. Don’t forget to sub for upcoming tutorials :D
very helpfull vid
oh lol. In that case the radio code should be in your owner’s manual. The phone # worked for me but my Acura is an ’02 😀
No the phone number was wrong haha the Car I bought new 🙂 hehe its a stock radio
That sucks, maybe the radio got swapped at some point before you owned the car…
haha I called the number and It didn’t work 🙁
no code = no tunes lol
why do you need the 5 digit radio code? sorry haha
ya buddy!
I just used this to help install a injen short ram-very close design-thanks,it did help me-injens instructions were pretty weak-but their intake is awesome!!!
Go to my channel page and watch the vid titled: Aggressive VTEC crossover RSX type S
I’m going to get this intake 4 my 06 RSX or might go with the v2 AEM can u post a video of how it sounds thanks.
good video and good information! took off my old intake and installed an AEM v2 short ram in less than 30 minutes thanks to u!
You can tell that kit was not an ebay chinese junk type kit because it bolted on without modification.