How to replace Rear wheel bearing – AUDI A4 Avant (8E5, B6) 2.0
mod. 2011
Tools: https://www.amazon.com/s?k=Hex+Bit+Socket+mm17+mm&ref=nb_sb_noss
#weelbearing#audi#tigernor
How to replace Rear wheel bearing – AUDI A4 Avant (8E5, B6) 2.0
mod. 2011
Tools: https://www.amazon.com/s?k=Hex+Bit+Socket+mm17+mm&ref=nb_sb_noss
#weelbearing#audi#tigernor
Comments are disabled for this post.
Should have torqued the axle bolt according to spec but good video nonetheless
Is this a FWD?
Just done mine, new hub and ABS sensor. The old hub bolt was a 19mm the new was a 17mm. No puller required. Hardest part was re-routing the new ABS sensor cable.
What kind of tool does he use to remove the wheel bearing screw?
what did you use to get the bearing off the shaft as your video cuts to a lose bearing which is never going to happen, very important bit in my eyes, Bearing puller ??
Did you use a sliding hammer to remove the hub or was it relatively easy to remove by hand??? Video doesnt show this
I can’t stop watching this video.
nice video, thx a lot
How u put the router back in
Does this apply to a 2006 Audi A4 fwd
What size bit was used to remove the bold behind the dust cap??